由VFD供电的交流感应电机
View the full transcript and gain access to JoVE Science Education videos
Q1: How does a variable frequency drive control AC induction motor speed?
A VFD controls motor speed by adjusting the output frequency and voltage supplied to the motor. The drive converts 60 hertz AC input to DC power using a rectifier, then uses a DC to AC inverter with pulse width modulation to generate AC output at the desired frequency. Since motor speed is proportional to input power frequency, changing the frequency directly controls motor speed.
Q2: What is the voltage to frequency ratio and why is it important in VFD operation?
The voltage to frequency ratio, or V/f ratio, is the relationship between output voltage and frequency maintained by a VFD. This ratio is approximately proportional to the stator magnetic field and motor speed. By maintaining a constant V/f ratio, VFDs preserve motor performance and efficiency. For example, a motor rated at 208 volts and 60 hertz has a V/f ratio of 3.5 volts per hertz that must be maintained during speed adjustments.
Q3: What are the advantages of soft starting a motor with a VFD?
Soft starting gradually increases motor speed to the desired level instead of instantly turning it on to full speed. This eliminates high starting torques and surge currents, reducing mechanical stresses on equipment. Soft starts increase equipment life and reliability while decreasing maintenance costs. Additionally, adjusting motor speed even slightly can save considerable energy since load torque and power vary with the square and cube of speed respectively.
Q4: How does open loop control differ from closed loop vector control in VFDs?
Open loop control outputs constant drive power without feedback or adjustments, maintaining a preset V/f ratio for speed regulation. Closed loop, or vector control, uses a microprocessor that receives feedback about the motor's magnetic field and torque, then continually adjusts VFD power according to a control algorithm. Most VFDs use open loop control when operating motors at or below rated voltage for simplicity and cost-effectiveness.
Q5: What happens when a VFD operates a motor above its rated frequency?
When operating above rated frequency, VFDs restrict output to the motor's rated voltage to prevent damage. This precaution avoids exceeding voltage or current limits of the motor's insulation and coils. For example, a motor rated at 208 volts and 60 hertz would not receive 460 volts when frequency increases to 120 hertz; instead, the VFD limits output to the rated 208 volts while maintaining safe operating conditions.
Q6: What are common industrial applications of variable frequency drives?
VFDs are used in fans, pumps, compressors, drills, and machining equipment like drill presses, lathes, and milling machines. In ventilation systems, VFDs allow fans to respond to temperature controls by increasing speed when temperatures are high or decreasing speed when temperatures are low. For machining, VFDs enable equipment versatility by allowing low-speed operations for plastics to prevent charring and high-speed operations for hard metals like steel.
Q7: How does pulse width modulation in a VFD generate AC output power?
A DC to AC inverter uses pulse width modulation to switch DC power on and off in a specific pattern. A low pass filter then transforms this pulse stream into a roughly sinusoidal waveform, generating AC output power at the chosen frequency. The sinusoidal waveform is necessary because most induction motors are designed to operate with power from AC mains, requiring smooth AC output rather than pulsed DC.