晶闸管整流器

A thyristor, also called a silicon controlled rectifier (SCR), conducts current in one direction from anode to cathode like a diode, but includes a gate terminal for control. Unlike a diode, a small current pulse to the gate is required to switch the thyristor on. The thyristor can also be switched off when forward current drops below a latching threshold, enabling precise power regulation.

Thyristors are four-layer devices composed of alternating P and N-type semiconductor materials, forming a PNPN structure with three junctions. The anode lead connects to P-type material at one end, the cathode connects to N-type material at the other end, and the gate connects to the P-type layer nearest the cathode.

The firing angle is the phase difference between the gate pulse and the zero crossing of the AC source. As the firing angle increases, the thyristor triggers later in the positive cycle, resulting in a more chopped output voltage and decreased mean output voltage. A zero-degree firing angle produces complete half-wave rectification, while higher angles progressively reduce power delivered to the load.

Thyristors are bi-stable devices that can rest in two states: forward conducting mode and blocking mode. In forward conducting mode, the thyristor conducts current as long as source voltage is positive and current remains above the latching threshold. In blocking mode, the thyristor blocks current in both directions until a gate pulse triggers it back into conduction.

Thyristors control power in light dimmers, motor speed controllers, and voltage regulators. Home and office light dimmers use a potentiometer to change thyristor firing angle, adjusting power to light bulbs. High-voltage thyristors also enable arc discharge applications like carbon nanotube synthesis and arc welding, where they control power that creates the electrical arc.

When working with 120-volt AC power, avoid contact with exposed wires to prevent electrocution and injury. Do not touch any circuit components while energized and do not ground the VARIAC. For comprehensive guidance, consult electrical safety precautions and basic equipment protocols before beginning experiments.

A small current pulse to the gate terminal switches the thyristor on, allowing forward current to flow from anode to cathode. This pulse must occur while the source voltage is positive; otherwise, the thyristor remains off and blocks current. Once triggered, the thyristor continues conducting as long as forward current stays above the latching threshold.